Titanium E Series 20mm Head (For Triple LED)

Write a review
$195.00
Ask a question
10 days
Price in points: 195 points
Ti-E-Head-Tri
Out of stock
  • Pinterest

IMPORTANT! These are NOT mass produced. If there are none in stock it will take aprox. 3-4 weeks to produce these and ship! Order your Custom Piece today!

Titanium E Series Compatible 20mm Head

Crenelated Bezel

Uses Triple LED and 20mm Optic

Heat Sink

Uses 14mm Drivers

Easy to build for the DIY'er

Standard FET Driver

  • 3-Mode (High / Med / Low)

GuppyDrv Rev 2. Driver

Rev.2 User Selectable Groups:

  1. 100% Only
  2. 5% - 100% | Memory
  3. 5% - 100% | No Memory
  4. 30% - 100% | Memory
  5. 30% - 100% | No Memory
  6. 70% - 100% | Memory
  7. 70% - 100% | No Memory
  8. ML - 30% - 100% | Memory
  9. ML - 30% - 100% | No Memory
  10. 100% - 30% - ML | No Memory
  11. ML - 5% - 15% - 50% - 70% - 100% | Memory
  12. ML - 5% - 15% - 50% - 70% - 100% | No Memory
  13. 100% - 70% - 50% - 15% - 5% - ML | No Memory
  14. Strobe Only
  15. 100% - Strobe | No Memory
  16. Strobe - 100% | No Memory
  17. 100% - 1Hz Blink | No Memory
  18. ML - 5% - 30% - 70% - 100% - Strobe - 1Hz Blink | No Memory
  19. 100% - 70% - 30% - 5% - ML - Strobe - 1Hz Blink | No Memory
  20. 5% - 30% - 100% - 1Hz Blink - 3Hz Blink - Strobe - Beacon | No Memory

Guppydrv Instructions

To switch mode groups: rapidly tap the switch 8 times, the light will then enter the programming mode and begin to flash. With the light in programming mode, tap the switch the same number of times as your desired mode group. The light will blink and your mode group will be memorized.

Example: To select mode group 3, tap the switch 8 times quickly to enter programming mode. As soon as the light enters programming mode and beings flashing, tap the switch three times. The light will blink to recognize the mode group change.

To set the turbo timer: rapidly tap the switch 8 times, the light will then enter the programming mode and begin to flash. With the light in programming mode, tap the switch 30 times to enter the turbo timer set mode. The light will then switch to 100% power. When the light is at the desired temperature for the turbo step down, turn the light off. The turbo timer will then be set. The turbo timer steps the light down to 50% regardless of the mode group set.

To lock the mode groups: Solder Pin 5 to ground. The other pins have no function with this firmware.


No reviews found